What Is Minimal invasive surgery?

Minimally invasive surgery allows your surgeon to use techniques that limit the size and number of cuts, or incisions, that they need to make. It’s typically considered safer than open surgery. You’ll usually recover more quickly, spend less time in the hospital, and feel more comfortable while you heal.

In traditional open surgery, your surgeon makes one large cut to see the part of your body that they’re operating on. In minimally invasive surgery, your surgeon uses small tools, cameras, and lights that fit through several tiny cuts in your skin. This allows your surgeon to perform surgery without opening a lot of skin and muscle.
Some minimally invasive surgeries are done with robotic technology that allows more precise control over the surgery. Other minimally invasive surgeries are done without robotic assistance.

What is Minimal invasive spine surgery:

In general, the goal of minimally invasive spine (MIS) surgery is to stabilize the vertebral bones and spinal joints and/or relieve pressure being applied to the spinal nerves often a result of conditions such as spinal instability, bone spurs, herniated discs, scoliosis or spinal tumors.

As opposed to open spine surgery, minimally invasive surgical approaches can be faster, safer and require less recovery time. Because of the reduced trauma to the muscles and soft tissues (compared to open procedures), the potential benefits are:

  • Better cosmetic results from smaller skin incisions (sometimes as small as several millimeters)
  • Less blood loss from surgery
  • Reduced risk of muscle damage, since less or no cutting of the muscle is required
  • Reduced risk of infection and postoperative pain
  • Faster recovery from surgery and less rehabilitation required
  • Diminished reliance on pain medications after surgery

In addition, some MIS surgeries are performed as outpatient procedures and utilize only local anaesthesia so there is less risk for an adverse reaction to general anaesthesia.
As with any surgical procedure, no matter how minimal, there are certain risks associated that include, but are not limited to:

  • Possible adverse reaction to the anaesthetic
  • Unexpected blood loss during the procedure
  • Localized infections, no matter how small the incision area

And, though uncommon, there is always a small chance that the initial MIS surgery cannot be completed, requiring either a second procedure or full open surgery.

Conditions Treated Using MIS Procedures

  • Degenerative disc disease
  • Herniated disc
  • Lumbar spinal stenosis
  • Spinal deformities such as scoliosis
  • Spinal infections
  • Spinal instability including spondylolisthesis
  • Vertebral compression fractures
  • Spinal tumors

How Minimally Invasive Spine Surgery Work

Because the spinal nerves, vertebrae and discs are located deep inside the body, any approach to gain access to the spinal area requires moving the muscle tissue out of the way. In general, this is facilitated by utilizing a small incision(s) and guiding instruments and/or microscopic video cameras through these incisions. Contrary to popular belief, lasers are very rarely used in MIS surgeries. A number of methods can be used to minimize trauma during MIS surgery. Some of the more common techniques are outlined here.

Common MIS Surgery Treatment Options

A number of specific techniques have been deployed for MIS surgery. Though the field continues to develop, the list below highlights some of the most common options.
Discectomy: Spinal discs are essentially elastic rings with soft material inside that serve as cushions between the vertebral bones. If the elastic ring becomes weakened, the soft tissue inside can extrude or herniate outside of the elastic ring. The herniated disc material can compress the nerves passing by, thus causing pain. If surgical treatment is recommended to trim or remove the herniated disc, it may be possible to perform this procedure with MIS surgery using tubular dilators and a microscope or endoscope.
Spinal decompression: Spinal stenosis, which is a narrowing of the vertebral canal, is a common condition that can result in compression of the nerves. This can produce a variety of symptoms, including pain, numbness and muscle weakness. If surgery is recommended, it may be possible to remove the bone and soft tissues causing the nerve compression through an MIS approach using tubular dilators and a microscope or endoscope. The more common decompressive procedures include laminectomy and foraminotomy.
Transforaminal Lumbar Interbody Fusion (TLIF): This is a MIS technique that is performed for patients with refractory mechanical low back and radicular pain associated with spondylolisthesis, degenerative disc disease and recurrent disc herniation. The procedure is performed from the back (posterior) with the patient on his or her stomach. Utilizing two small incisions, screws and rods are placed between two or more vertebral levels. The intervertebral disc is removed and a cage filled with bone is placed in that void with the goal of stabilizing the levels affected.

Candidates for MIS Surgery:

A doctor will be able to tell which MIS surgeries, if any, might be an option for treating a spinal condition. In some situations, MIS surgery may not be as safe or effective as traditional open surgery. If so, the doctor will be able to inform you about the relative risks and benefits. In addition, there are some conditions that are not truly treatable with MIS surgery.
Spinal Fusion:
Spinal fusion is an operation that creates a solid union between two or more vertebrae. This procedure may assist in strengthening and stabilizing the spine and may thereby help to alleviate severe and chronic back pain.
Almost all of the surgical treatment options for fusing the spine involve placement of a bone graft between the vertebrae. Bone grafts may be taken from the hip or from another bone in the same patient (autograft) or from a bone bank (allograft). Bone graft extenders and bone morphogenetic proteins (hormones that cause bone to grow inside the body) can also be used to reduce or eliminate the need for bone grafts.
Fusion may or may not involve use of supplemental hardware (instrumentation), such as plates, screws and cages. This fusing of the bone graft with the bones of the spine will provide a permanent union between those bones. Once that occurs, the hardware is no longer needed, but most patients prefer to leave the hardware in place rather than go through another surgery to remove it. Fusion can sometimes be performed via smaller incisions through MIS techniques. The use of advanced fluoroscopy, endoscopy and navigation has improved the accuracy of incisions and hardware placement, minimized tissue trauma while enabled an MIS approach.

MIS Fusion Procedures:

  • Minimally Invasive Lateral Interbody Fusion
  • Minimally Invasive Posterior Lumbar Interbody Fusion (PLIF)
  • Minimally Invasive Transforaminal Lumbar Interbody Fusion (TLIF)
  • Minimally Invasive Posterior Thoracic Fusion